Tried not working. It keeps resetting after few days.You can give a try to Wi-Fi repeater. Might be possible that antennas on switches are weak or not that good to catch the range.
I am using one of those Homemate 4 gang touch device, never had any issues..
how far is the device from the router?
yes same switches (white color), I have two and both working fineTried not working. It keeps resetting after few days.
View attachment 177663
You have these switches installed ?
Then what could be the problemyes same switches (white color), I have two and both working fine
I also contacted the company but no response.Then what could be the problem
I installed the repeter and the signal strength is -45db
Shoud i reflash the firmware (if thats possible)
Or shoud i just change the tuya cb3s module with an esp 12 and go with the tasmota route
Please suggest a fix .
just recently for both Homemate Switches I flashed OpenBeken firmware (similar to Tasmota) via Tuya Cloud cutterThen what could be the problem
I installed the repeter and the signal strength is -45db
Shoud i reflash the firmware (if thats possible)
Or shoud i just change the tuya cb3s module with an esp 12 and go with the tasmota route
Please suggest a fix .
well thanks for the info will give it a try and let you know .just recently for both Homemate Switches I flashed OpenBeken firmware (similar to Tasmota) via Tuya Cloud cutter
its working perfectly on Home Assistant (u can use those switches even without Home Assistant)
can you please suggest me a video tutorial or a guideIts a easy process, u just need a Raspberry Pi or any Laptop/desktop where u can install Linux and then Tuya Cloud cutter
and u should have a Wifi card which supports Access point
UPDATED Tuya-CloudCutter with ESPHome Beken Devices | How To Guide Home Assistant - YouTubewell thanks for the info will give it a try and let you know .
can you please suggest me a video tutorial or a guide
also can i use my MacBook instead of Linux install as my pi3b is not booting up