Question to start with : Does the hardware buttons ( Router, Repeater, AP) have any impact after flashing DD-WRT.
To the main issue - I am trying to set my Asus N13u ( with DD-WRT) in repeater mode for SGS3 Wifi hotspot. But I am not able to get the router logon to the hotspot.
Using the guide here.
1) Setting the router as repeater ( and not repeater-bridge)
2) Tried changing hardware button positions
3) Set Wifi hotspot without any security
4) My laptop is able to connect to the hotspot with - 192.168.43.xxx
5) Router's own subnet defined as 192.168.2.xxx
6) DHCP enabled.
7) Tried all above again after (hard) resetting the router, but no use.
Any suggestions what I could be doing wrong.
PS : I can understand networking terminology and follow instructions but I am not an expert.
To the main issue - I am trying to set my Asus N13u ( with DD-WRT) in repeater mode for SGS3 Wifi hotspot. But I am not able to get the router logon to the hotspot.
Using the guide here.
1) Setting the router as repeater ( and not repeater-bridge)
2) Tried changing hardware button positions
3) Set Wifi hotspot without any security
4) My laptop is able to connect to the hotspot with - 192.168.43.xxx
5) Router's own subnet defined as 192.168.2.xxx
6) DHCP enabled.
7) Tried all above again after (hard) resetting the router, but no use.
Any suggestions what I could be doing wrong.
PS : I can understand networking terminology and follow instructions but I am not an expert.